| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Setting neck angle string compensation http://www-.luthiersforum.com/forum/viewtopic.php?f=10122&t=45030 |
Page 1 of 1 |
| Author: | Cablepuller [ Sun Feb 01, 2015 4:46 am ] |
| Post subject: | Setting neck angle string compensation |
Hi Have dry fitted neck and all looks good, i have checked the height at bridge position and have 9mm with unfretted fretboard and 2.5mm with just neck. Fretted this will land ontop of bridge Should i set the neck back a bit to allow for a bit of movement under string tension? Thanks |
|
| Author: | Hesh [ Sun Feb 01, 2015 7:25 am ] |
| Post subject: | Re: Setting neck angle string compensation |
This may help, posted in your other thread too: http://www.luthiersforum.com/forum/viewtopic.php?f=10102&t=15022%22 Over compensating neck angle is not advisable or necessary. |
|
| Author: | Cablepuller [ Sun Feb 01, 2015 7:26 am ] |
| Post subject: | Re: Setting neck angle string compensation |
Ok thanks hesh |
|
| Author: | Hesh [ Sun Feb 01, 2015 7:35 am ] |
| Post subject: | Re: Setting neck angle string compensation |
You are very welcome - some of the comments also will be helpful such as Colin's comment about backing the sandpaper with tape to help it keep from tearing. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|